Skip to content

Net run rate calculator

Cricket NRR for a team, and what it needs to qualify.

Net run rate–

Enter at least one match.

Scored
Conceded
Scored
Conceded
Scored
Conceded

Mini points table

TeamPtsNRR –

Points: win 2, tie or no result 1, loss 0. Leave yours blank to count from the matches above.

What do we need in the next match?

Overs are written 19.4 for 19 overs and 4 balls. Tick All out when a side lost its tenth wicket: the ICC counts a full quota of overs for it. For a rain-affected match, enter the figures the competition credits (see the table below). This calculator is for information only and is not financial advice.

How is net run rate calculated?

Net run rate is the runs a team scores per over minus the runs it concedes per over, with both worked out from the totals of every counted match, not averaged match by match. Three default matches in the calculator above give 514 runs from 60.0 counted overs and 464 conceded from 56.2, which is a net run rate of +0.330. The ICC's competition clause states it as the average runs per over scored, less the average runs per over scored against the team.

Formula · net run rate
NRR = (total runs scored ÷ total overs faced) − (total runs conceded ÷ total overs bowled)

Overs are counted in balls and divided by six. A side all out early is counted as having faced its full quota. A match with no result is left out.

Three matches pooled (T20, 20-over quota)
MatchScoredCountedConcededCounted
Match 1 178 in 20.0 20.0 152 all out in 17.4 20.0
Match 2 141 all out in 18.3 20.0 142 in 16.2 16.2
Match 3 195 in 20.0 20.0 170 in 20.0 20.0
Total 514 60.0 464 56.2

Source: calculated with this tool; the scores are an example, not real fixtures.

Match 2 is the instructive one. The team was all out in 18.3 overs, but 20.0 overs go into the total. The fraction calculator can check the division if you want to do it by hand, and because a run rate is a ratio of runs to overs, the ratio calculator gives the same per-over figure for a single innings.

How do you write overs like 19.4?

The digit after the point counts balls, not tenths: 19.4 is 19 overs and 4 balls, or 118 balls, which is 19.667 overs. The ICC's conditions define an over as six valid balls, so only .0 to .5 can follow the point, and the calculator rejects 19.6 or 19.7. Typing 19.4 into a spreadsheet as a plain number overstates the rate.

19.4 overs = 19 complete overs + 4 balls of the 20th 19 overs · 114 balls 4 faced, 2 to come 114 + 4 = 118 balls, and 118 ÷ 6 = 19.667 overs
Each small block is one ball of the 20th over.
Overs notation against real overs
WrittenBallsTrue oversTrue minus written
0.1 1 0.167 0.067
6.3 39 6.500 0.200
19.4 118 19.667 0.267
19.5 119 19.833 0.333
20.0 120 20.000 0.000

Source: calculated from 6 balls to the over (ICC playing conditions, clause 17.1).

What counts when a team is all out?

A team dismissed before its quota is treated as having batted the whole quota. The ICC clause bases the calculation on the full quota of overs the team was entitled to, not the overs in which it was dismissed. The same applies when the opposition is all out: your bowling side is credited with the full quota too, so bowling a side out early lowers the rate you concede by less than the raw overs suggest.

One match, two treatments: all out for 120 in 15.0, opponents 121/3 in 18.0
MethodScoring rateConceded rateMatch NRR
Actual overs (wrong) 8.000 6.722 +1.278
Full quota (ICC rule) 6.000 6.722 -0.722

Source: calculated with this tool; rule from ICC Men's CWC League 2 playing conditions, 16.10.3.

Using the real overs would overstate this match by 2.00 runs per over in the scoring rate.

How do rain and no-results count?

A no-result match is left out of net run rate entirely. For a match that finishes under Duckworth-Lewis-Stern (DLS), the ICC clause credits the side that batted first with a substitute score, so the maths still compares like with like. Competitions can word this differently, so check the event's own regulations.

How the ICC clause treats each situation
SituationWhat goes into NRR
No result The match is not counted. Run rate does not apply.
Abandoned, DLS result Team 1 is credited with Team 2’s par score on abandonment, off the overs Team 2 faced.
DLS applied earlier, match completed Team 1 is credited with 1 run less than Team 2’s final target, off the overs allotted to Team 2.
Team all out early Counted as the full quota of overs it was entitled to.

Source: ICC Men's CWC League 2 playing conditions, clauses 16.10.1 and 16.10.3.

To enter a DLS match, replace the first innings with the credited figures. The side that batted first enters Team 2's par score (or final target minus 1) as runs scored, over the overs Team 2 faced or was allotted; Team 2 enters its actual score and those same overs. The quota is one setting for the whole table, so for a reduced-overs match leave All out unticked and enter the overs the competition credits.

What margin passes a rival?

Fix the rival's NRR, then ask how large a win or how quick a chase lifts yours past it. Batting first, the answer is the most runs the opposition may score in their full quota; chasing, it is the latest ball you can win on. The solver above runs both against your current totals and treats a tie on NRR as not passing.

Batting first: to pass +0.350 from +0.330
We scoreRestrict them toWin by at leastNRR then
160 in 20 overs 152 or fewer 8 runs +0.355
180 in 20 overs 171 or fewer 9 runs +0.356
200 in 20 overs 190 or fewer 10 runs +0.357

Source: calculated with this tool from the three example matches above.

Chasing: to pass +0.350 from +0.330
TargetWin by the end ofNRR then
Chase 141 19.1 overs +0.361
Chase 161 19.1 overs +0.352
Chase 181 19.0 overs +0.361

Source: calculated with this tool; the opposition is assumed to use its full 20 overs.

A chase counts overs, so winning with balls to spare is worth far more than winning with wickets to spare. Scoring more than the target changes your runs total too; the solver assumes the bare minimum, so any extra is a margin of safety. To see how much a rate change is in percent terms, the percentage calculator does the arithmetic.

Does NRR decide who qualifies?

Only after points. In the ICC's CWC League 2 conditions, teams level on points are split first by wins and then by net run rate, and a win is worth 2 points against 1 for a tie or no result. Other events set their own order, so read the tournament's regulations before using NRR as a qualification forecast. The mini table here ranks by points then NRR, which matches most leagues but skips the wins step.

What this calculator leaves out

  • Your rival's own matches. Their NRR moves when they play, so a target typed today may be stale by the match.
  • Mixed quotas. One overs setting applies to every row. For a reduced match, enter the credited figures against the quota you used.
  • Wins tie-break. The table does not apply a wins step before NRR.
  • Super overs. The ICC page we checked does not say how a super over affects NRR, so enter the regular innings.

Sources

Last reviewed November 17, 2026. Figures in examples are illustrative. Event regulations take precedence over the ICC text. This calculator is for information only and is not financial advice.